DIY Remodeling plans for 2016 year.

The plans for this year’s remodeling include the front entry of the house and new french doors. We knew when we bought the house that the front entry area was in poor shape not only on the inside but on the outside also. There are several problems we will be tackling over the next few months and maybe even into next year.

The Problems are #1. the exterior of the front entry is “Fake” stone. They are a molded cement that is the painted with the color and look of real stone. It is then applied to a board with mortar like tile. The problem is that the stones are attached incorrectly and the stones do not have enough mortar to hold securely. Leaving the stones open for water damage and just the effects of gravity have pulled the stones away from the plywood underneath . We have several “stones” that have fallen off and are just stacked up on the porch.

Problem #2 The doors are old and not very airtight, making them drafty and not as energy-efficient as they should be.

Problem # 3 The amount of light that passes through the windows on the doors is not installed with U.V.Ray protective glass and the amount of heat and sun damage from the windows is an issue.

Problem #4 the inside of the entryway looks fine but needs updated with new lights and some wood and stone to tie it with the family room remodel.

So as spring approaches I need to get started on looking at new energy-efficient french doors. I want less glass and the glass that in the new doors must be U.V. Ray reducing.  We hope to install new flooring in the kitchen some time in the future and I want to eliminate the possibility of fading to a new floor. I also want less glass because the doors are on the western side of  the house. The sun just burns through the current windows allowing too much heat into the house the afternoons.

I will be working with a contractor who will be help us with measurements and ordering the new doors and will return again for installation. French doors are a two or three-man job for installation and Tom and I will need all the help we can get to get them into place in one day.

As for the tile on the outside of the house we will replace the doors first and allow any of the old facade to become damaged or cut away before we even think about replacement. Once the doors are in place, the removal of the fake stone will begin and we will be ready to order the new tile. We are planning on using Ledger Tile with natural colors of sandstone to blend in with the brick of the house. The application will be almost the same as the “fake stone” but done with better water-resistant backer boards and lots more mortar.

The inside may not get completed this summer as Tom is going to have Carpal Tunnel surgery, but the plan is to add two wall sconce lights on each side of the doors, remove a ceiling light, and add new wood trim and more Ledger Tile. So the summer work plan is just about to begin and I am excited to get started. The doors are the most important part of the project and our goal is to have them finished before the summer heat keeps us inside. The rest will wait on Tom’s recovery.

We have been having a hard time finding samples of ledger tile here in West Virginia. I am upset that Home Depot does not have them in their stores in my state but have them in Pa.  We can see them  online so Tom and I plan a trip to some of the bigger retailers out-of-state over the summer while he is unable to actually do the work but can see the materials. Sometimes living in the country can making things a little more complicated.

So when we get a few things ordered I will share the plans and photos as we update the doors and stone work. The year looks full of more fun and learning as we learn more about installing new doors, tile and mortar and correct applications outside.